This requirement is to purchase a device to cut steel, aluminum, plexiglass, honeycomb, foam, composites etc. with a maximum thickness of 12 inches. The current methods of cutting thick materials are limited to a hand held circular saw which only has 3 inch capacity.

The water jet must have the following features:

- Must be 480 VAC/3 Phase system

- Cutting pressure output of 60,000 PSI (Pounds per Square inch)

- Maximum 50 Horsepower direct drive pump motor

- Optimum .016” cutting orifice/1.20 GPM flow rate

- Maximum foot print area of 15’ 2” x 8’ 10”

- Cutting bed area 8’3” x 4’6” minimum

- Maximum table load 400 Lbs. sq ft.

- Maximum 180 in/min cutting speed

- Noise level less than 80 dba at 1 meter for submerged cutting

- Linear positional accuracy must be less than 0.0015”

- Repeatability must be less than 0.0015”

- Ballbar Circularity must be less than 0.003”

- Minimum X and Y travel must be 8’ 4” x 4’ 7”

- Minimum 7.5” Z axis travel

- Must be capable of cutting alum, stainless steel, carbon steel, copper, titanium, tool steel, brass, carbon fiber, fiberglass,

Kevlar, phenolic.

- Five (5) Day Training included

- The factory technician will start the machine to assure it's operation, immediately following start-up the technician will provide

3 Days on-site Training.

- Installation of electrical components

- Installation of plumbing services for the waterline